Palmers Green, London N13 5SY. Provides both Hot Air for Winter and Cold / Cool Air for Summer.
This is an industrial grade portable air conditioner & ideal for an Open Office, Shop, Workshop or Mechanical shop. 1 Auto Mode Icon 2 Fan Speed 3 Cooling Mode Icon 4 Temperature & Timer Setting 5 Timer On 6 Temperature? 7 Dry Mode Icon 8 Heat Mode Icon. Power Turns the unit on/off. Temp Up Increases set temperature.
Temp Down Decreases set temperature. Speed Changes the fan speed. Full Lamp Indicates water full.
Exhausting the Air It is necessary to use the exhaust hose when using the machine. When in Cooling Mode hot air will be expelled out of the exhaust hose When in Heating Mode cold air will be expelled out of the exhaust hose. Check that the Exhaust Hose has been mounted properly (see'Installation' section). Hose is not correctly used, hot air will blow back into the room you are trying cool.Check that the drain plug at the bottom rear of the unit is securely plugged in, to prevent water leaks. (see page 9 - Water Drainage). Check that the location of the unit is suitable (flat, stable surface; away from sources water / heat). If the unit has recently been transported, let it stand for 6 hours to allow the compress contents to. Press the "Mode" button till the "Cool Mode" icon appears.
Button to select a desired room temperature. Press the "Fan Speed" button to select wind speed. NOTE: During hot days, the unit will cool off the room most efficiently by setting the temperature at the lowest. And the fan speed at the highest.
Reducing the length of the exhaust hoses, insulating the exhaust hoses. And keeping direct sunlight to a minimum will also improve the cooling efficiency. Press the "Mode" button till the "Heat Mode" icon appears. Press the "Mode" button till the "Dry Mode" icon blinks. Set the selected temperature to current room temperature minus 2?
Set the fan motor to LOW wind speed. According to the current room temperature the unit will automatically select the mode - cooling, dehumidifying.
When the room temperature is. When the room temperature is 23C - 26C the unit will enter Dry Mode. When the room temperature is =26? The unit will enter Cooling Mode. When the air-conditioner is OFF, press the "Timer" button and select a desired ON time through the. Temperature and time setting buttons. "Preset ON Time" is displayed on the operation panel. ON time can be regulated at any time in 0-24 hours. When the air-conditioner ON, press "Timer" button and select a desired OFF time through the temperature. "Preset OFF Time" is displayed on the operation panel. OFF time can be regulated at any time in 0-24 hours. When the unit is in cooling mode, unwanted water is extracted from the air.Most of this water is re-used to. Cool the unit and make it run more efficiently. When the unit is used in extremely humid environments, water. Will collect in a water container at the bottom of the unit.
When the water container is full, the compressor will. Stop but the fan will continue to run. When the water container is full, the unit will display'E2/E4' by means of the Water Indicator Full lamp being.
Illuminated on the control panel until the tank is emptied. To resume operation, empty the water container.
According to the following steps. Try not move the unit when the water container is full (can cause spillage). Place a drain pan under the drainage port at the back of the unit (perhaps use a shallow tray). Remove the rubber plug from the drain hole & drain water. Once the water container has been emptied, replace the rubber plug into the drain hole firmly.
This item is in the category "Home, Furniture & DIY\Heating, Cooling & Air\Air Conditioners\Portable Air Conditioners". The seller is "kartcopia" and is located in this country: GB. This item can be shipped to United Kingdom.