NOTE: This is a 3ph 400v outdoor unit, so you will need to have a suitable three phase supply available. (it will not run from 1 ph 230v) The pictures of the indoor unit show two units'Back to back' this is for storage only - so the indoor unit will be half the depth shown.
A Condensate pump is located in the base of the unit to remove waste water from cooling - this will need to be connected and wired up accordingly if you need to use it. The unit has the original factory charge of 4.5 R410a inside it and the ends all sealed. This will enable a run of up to 30m to be accommodated without further charging. This system will need to be installed and. By a qualified F-Gas Registered Engineer and the pipework required 5/8 and 3/8 plus 4 core 1.5mm cabling between the two.Power supply to outdoor unit. We can supply all pipework, insulation, cabling and drain etc if required (extra). So grab yourself a bargain while i have available. If you need more information on it go to. Google - Tap in'Mitsubishitech PSA-RP125K' and see what comes up (GA is the same model).
This is a good system and will not be on here long - so...... You are very welcome to view (by appointment only) - Located in Paddock Wood - Kent. The item "Mitsubishi Air Conditioning PSA-RP125 Floor Cabinet Heat Pump Inverter 12.5 Kw" is in sale since Thursday, September 13, 2018. This item is in the category "Home, Furniture & DIY\Heating, Cooling & Air\Air Conditioners & Heaters\Central Air Conditioners". The seller is "coolingspares-uk" and is located in Tonbridge.
This item can be shipped to all countries in Europe.